Hitachi Vantara Pentaho Community Forums
Results 1 to 2 of 2

Thread: Escaping Special Characters

  1. #1
    Join Date
    Feb 2016
    Posts
    27

    Default Escaping Special Characters

    My value will work as a parameter or as itself in all cases except one.

    In this one particular case, I have an amersand(&) value. So the parameter is pointing to this value and it has an ampersand.

    If I put in the value itself, it works fine.

    If I put in the parameter pointing to the value, it does not work.

    I tried putting a backword slash, \, character in front, but had no luck.

    What do you guys think?

  2. #2
    Join Date
    Jun 2013
    Posts
    24

    Default

    Can you provide any more detail? Where is this value being set - in the Parameters tab of a job or transformation, or somewhere else? What are you doing with it when you encounter the error?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Privacy Policy | Legal Notices | Safe Harbor Privacy Policy

Copyright © 2005 - 2019 Hitachi Vantara Corporation. All Rights Reserved.