Hitachi Vantara Pentaho Community Forums
Results 1 to 4 of 4

Thread: Parameters

  1. #1

    Default Parameters

    Hi,

    I am trying to use a parameter within a table input(select ?, field1, field2 from table134), but all I get is "Parameter #1 has not been set." I have followed the documentation and used a "Get system data" step but no change. Can you pls advise? I am using Version 2.4

    Thanks a lot

  2. #2

    Default

    Hi,

    Did you filled "Insert data from step" in table output ?
    This kind of process works so please give us more infos (picture, decription or best sample)

    Thanks

    Samatar

  3. #3

    Default

    Hi,

    I have tried any combination of 'replace variables' and 'insert data'. Still the message is 'Parameter #1 has not been set' or more fatal than that. I have attached parameters.ktr. The ? in 3rd step are to be filled with thedate from the 1st. Maybe you can amend the flow the way it works.

    Thanks a lot

    ohatnep
    Attached Files Attached Files

  4. #4

    Default

    I have figured it out. I have correctly connected two table inputs using the question mark in the 2nd and the transformation works properly. the problem is the preview button. It displays the error message but the transformation is OK.

    nonetheless thanks a lot

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Privacy Policy | Legal Notices | Safe Harbor Privacy Policy

Copyright © 2005 - 2019 Hitachi Vantara Corporation. All Rights Reserved.