Hitachi Vantara Pentaho Community Forums
Results 1 to 2 of 2

Thread: Data Integration Output File Content w/ Xaction BI Platform

  1. #1

    Default Data Integration Output File Content w/ Xaction BI Platform

    Reference: http://forums.pentaho.org/showthread.php?p=159491

    A fixed-width data file, already in place and created in Data Integration (kettle). Unable to send that file back out through as Xaction output.

  2. #2

    Default

    2nd note after more testing - the requirement is for fixed-width report from a datastream (identified errors during scrubbing/validation report on a fixed-width file in a defined way...not the Kettle errors, but ModJS defined error codes).

    Using a Kettle result-set with an XACTION to create a fixed-width report has been challenging. JfreeReport finds it very challening to do fixed-width, but is feasible with careful deliberation outside of the Designer. BIRT also can do fixed-width supposedly, but I personally would be going through a new learning curve and choose not to go down that route.

    In the end, just wrote the fixed-width file from Kettle to a disk location by convention, and read the file and just sent the stream back through the browser with a servlet.

    Hopefully in the future problem/challenges like this can become easier.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Privacy Policy | Legal Notices | Safe Harbor Privacy Policy

Copyright © 2005 - 2019 Hitachi Vantara Corporation. All Rights Reserved.