Hitachi Vantara Pentaho Community Forums
Results 1 to 3 of 3

Thread: How to debug a job that hangs?

  1. #1
    Join Date
    May 2007
    Posts
    19

    Unhappy How to debug a job that hangs?

    Hi all,

    I have a pretty complex job comprised of several transformations that runs fine with Kettle 2.5. I am now trying to run it with 3.0RC1, but at some point in the process the UI hangs. How can I track the problem if the program just hangs? I just don't get to see a debug output...

    Any suggestions welcome.

  2. #2
    Join Date
    May 2006
    Posts
    4,882

    Default

    You have a debug mode in 3.0 ... I would remove steps from output to input until it works again.

    Regards,
    Sven

  3. #3
    Join Date
    May 2007
    Posts
    19

    Default

    Yeah, I guess I'll have to do that.

    I just tried to run it from the command line and it hangs too. I can't even ctrl-C it...

    Thanks

    François

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Privacy Policy | Legal Notices | Safe Harbor Privacy Policy

Copyright © 2005 - 2019 Hitachi Vantara Corporation. All Rights Reserved.