Hitachi Vantara Pentaho Community Forums
Results 1 to 2 of 2

Thread: Transformation

  1. #1
    Join Date
    Jun 2007
    Posts
    128

    Default Transformation

    Hi,

    I am running a transformation.
    If there is an error while loading transformation will stop.So i would like to know is there any way to make a transfomation to run from the point where it got stopped after solving the problem(after the error got rectified).?
    Can we do this in Kettle?

    Thanks
    Sreelatha

  2. #2
    Join Date
    May 2006
    Posts
    4,882

    Default

    No, not unless you make your own restart points.

    Regards,
    Sven

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Privacy Policy | Legal Notices | Safe Harbor Privacy Policy

Copyright © 2005 - 2019 Hitachi Vantara Corporation. All Rights Reserved.