Hitachi Vantara Pentaho Community Forums
Results 1 to 2 of 2

Thread: Command line parameters for job

  1. #1

    Default Command line parameters for job

    I have had success and fun using PDI but have strugled with command line parameters.

    I need to pass a short string in and use this string in the where clause of a table input in the first transformation in the job (typically launched with kitchen).

    I can access this when launched by kitchen but have a bear of a time testing from the spoon GUI ... am I missing something?

    Thanks

  2. #2
    Join Date
    May 2006
    Posts
    4,882

    Default

    Just supply arguments to spoon. When spoon starts up you can see them under Edit/Show arguments.

    There were however a few problems in 2.5 with arguments in spoon... which should normally be fixed in 3.0

    Regards,
    Sven

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Privacy Policy | Legal Notices | Safe Harbor Privacy Policy

Copyright © 2005 - 2019 Hitachi Vantara Corporation. All Rights Reserved.