Hitachi Vantara Pentaho Community Forums
Results 1 to 6 of 6

Thread: Spoon problems

  1. #1

    Default Spoon problems

    I'm experiencing a very frustrating problem in Spoon (2.5.2, but also occurred in 2.5.0). I will open a Job from the Repository, right click on a transformation and open it. Go back to the job tab and spoon does not recognize it as a job, it thinks it is a transformation. The same thing happens where it thinks a transformation is a job. The end result is not being able to run the job or transformation, and not being able to save them either. The solution is to close the tab, reopen the file (Spoon then warns that the job/trans is already open). But the problem will resurface shortly thereafter.

  2. #2
    Join Date
    May 2006
    Posts
    4,882

    Default

    It was/will be fixed in 3.0.0GA

    Regards,
    Sven

  3. #3

    Default

    Is it something I can backport? Does this have an issue in Jira?

  4. #4
    Join Date
    May 2006
    Posts
    4,882

    Default

    It was fixed during the UI-split of the jar files in 3.0. No JIRA, and a little buried but no too difficult too fix if I remember correctly.

    Raise a JIRA for 2.5.2

    Regards,
    Sven

  5. #5

    Default

    I'm still experiencing this with 3.0.0GA.

  6. #6
    Join Date
    May 2006
    Posts
    4,882

    Default

    Raise a JIRA, but I can't simulate it for the moment.

    Regards.
    Sven

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Privacy Policy | Legal Notices | Safe Harbor Privacy Policy

Copyright © 2005 - 2019 Hitachi Vantara Corporation. All Rights Reserved.