Hitachi Vantara Pentaho Community Forums
Results 1 to 3 of 3

Thread: end job without abort

  1. #1
    Join Date
    Sep 2008
    Posts
    26

    Default end job without abort

    Is there a way that I can end a job without using Abort?

    the problem with abort is that it reports an ERROR when running the job and when using kitchen it returns error for the job. I want to monitor my jobs, but this is really posing a problem.

    I have the abort when there are no new records to update, do it is based on the fail of a simple evaluation. I need to stop the job, but not report and error as it is a normal exit.

    Thanks
    Des

  2. #2
    Join Date
    Sep 2009
    Posts
    810

    Default

    Hi there,

    you can use "success" entries to end your jobs (they are in the "general" section)

    Cheers

    Slawo

  3. #3
    Join Date
    Sep 2008
    Posts
    26

    Default

    Problem is it cannot stop a job that has repeat set in the start step. Would be good if this step also stopped any repeats.

    I have found a way to repeat part of the job by using a loop back to the start thus avoiding the repeat in the start step and using success to exit on a certain condition


    Thanks
    Des

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Privacy Policy | Legal Notices | Safe Harbor Privacy Policy

Copyright © 2005 - 2019 Hitachi Vantara Corporation. All Rights Reserved.